Nortel Networks 5500 series - Manual (Page 20)

20 Introduction
italic text Variables in command syntax descriptions. Also
indicates new terms and book titles. Where a
variable is two or more words, the words are
connected by an underscore.
Example: If the command syntax is
show at <valid_route> ,
valid_route is one variable and you substitute
one value for it.
plain Courier text Command syntax and system output, for example,
prompts and system messages.
Example: Set Trap Monitor Filters
separator ( > ) Menu paths.
Example: Protocols > IP identifies the IP
command on the Protocols menu.
vertical line ( | ) Options for command keywords and arguments.
Enter only one of the options. Do not type the
vertical line when entering the command.
Example: If the command syntax is
show ip {alerts|routes} , you enter either
show ip alerts or show ip routes , but not
both.
Related information
This section lists information sources that relate to this document.
Publications
Refer to the following publications for information on the Nortel SNAS:
•
Nortel Secure Network Access Solution Guide, (NN47230-200)
•
Nortel Secure Network Access Switch 4050 Installation Guide ,
(NN47230-300).
• Nortel Secure Network Access Switch 4050 User Guide for the CLI
(NN47230-100),
• Installing and Using the Security,
• Release Notes for Nortel Ethernet Routing Switch 5500 Series,
Software Release 5.0.1,
•
Release Notes for the Ethernet Routing Switch 8300, Software
Release 2.2.8 ,
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.