About the ip addresses, Management ip address, Portal virtual ip address – Nortel Networks 5500 series User Manual

Page 42: About the ip

Advertising
background image

42

Initial setup

— network access devices

— remediation server (if applicable)

For more information about the Nortel SNAS MIP, pVIP, and
RIP, see

“About the IP addresses” (page 42)

.

VLAN IDs

— Nortel SNAS management VLAN

— Red VLANs

— Yellow VLANs

— Green VLANs

— VoIP VLANs (optional)

Groups and profiles to be configured

2

Configure the network DNS server, DHCP server, core router,
and network access devices, as described in

“Nortel SNAS

configuration roadmap” (page 37)

, steps

1

through

4

.

3

Install the Nortel SNAS device. For more information, see
Nortel Secure Network Access Switch 4050 Installation Guide
, (NN47230-300).

4

Establish a console connection to the Nortel SNAS (see

“Establishing a console connection” (page 378)

).

--End--

About the IP addresses

Management IP address

The Management IP address (MIP) identifies the Nortel SNAS in the
network. In a multi-Nortel SNAS solution, the MIP is an IP alias to one
of the Nortel SNAS devices in the cluster and identifies the cluster. The
MIP always resides on a master Nortel SNAS device. If the master Nortel
SNAS that currently holds the MIP fails, the MIP automatically migrates to
a functional master Nortel SNAS. In order to configure the Nortel SNAS or
Nortel SNAS cluster remotely, you connect to the MIP using Telnet (for the
CLI) or SSH (for the CLI, the SREM or the BBI).

Portal Virtual IP address

The portal Virtual IP address (pVIP) is the address assigned to the Nortel
SNAS device’s web portal server. The pVIP is the address to which clients
connect in order to access the Nortel SNAS network. While the client is in
the Red VLAN and the Nortel SNAS is acting as DNS server, the pVIP is
the DNS server IP address. Although it is possible to assign more than
one pVIP to a Nortel SNAS device, Nortel recommends that each Nortel
SNAS have only one pVIP. When the Nortel SNAS portal is configured as
a captive portal, the pVIP is used to load balance logon requests.

Nortel Secure Network Access Switch

Using the Command Line Interface

NN47230-100

03.01

Standard

28 July 2008

Copyright © 2007, 2008 Nortel Networks

.

Advertising
This manual is related to the following products: