Nortel Networks 5500 series - Manual (Page 494)

494 Configuring DHCP to auto-configure IP Phones
For information on the minimum firmware versions required to support
IP Phones in the Nortel SNAS, see Release Notes for the Nortel Secure
Network Access Solution, Software Release 1.6.1 (NN47230-400), .
Configuring IP Phone auto-configuration
To configure Windows 2000 Server DHCP to auto-configure the IP
Phones, perform the following steps:
Step Action
1 Create DHCP options (see “Creating the DHCP options” (page
494) )
•
Call Server Information
• VLAN Information for auto-discovery of the IP Phone VLAN
ID
2 Configure the DHCP options (see “Configuring the Call Server
Information and VLAN Information options” (page 497) )
Repeat this step for the data (or boot) VLAN and the Phone
VLAN.
3 Set up the IP Phone (see “Setting up the IP Phone” (page 500) )
--End--
Creating the DHCP options
Step Action
1 On the Windows 2000 Server Start menu, select Programs >
Administrative Tools > DHCP.
The DHCP Management Console opens (see Figure 33 "The
DHCP Management Console" (page 495) ).
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.