Nortel Networks 5500 series - Manual (Page 55)

Applying and saving the configuration 55
e If you did not run the quick setup wizard during the initial
setup, configure the following:
• Create the domain (see “Creating a domain” (page 83) ).
• Create at least one group.
• Specify the VLANs to be used when the Nortel Health
Agent check succeeds and when it fails (see
“Configuring
extended profiles” (page 164) ).
4 Save the configuration (see “Applying and saving the
configuration” (page 55) ).
--End--
Applying and saving the configuration
You must enter explicit commands in order to make configuration changes
permanent and in order to create a backup configuration file.
If you have not already done so after each sequence of configuration
steps, confirm your changes using the
apply command.
To view your configuration on the screen, for copy and paste into a text
file, use the following command:
/cfg/dump
To save your configuration to a TFTP, FTP, SCP, or SFTP server, use the
following command:
/cfg/ptcfg
For more information, see “Backing up or restoring the configuration” (page
356) .
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.