KYORITSU 6310 Instruction Manual - Manual (Page 10)

Safety warnings KEW6310
9
KEW6310
WARNING
- Connection -
● Confirm that the instrument is off, and then connect the Power cord.
● Connect the Voltage test leads and clamp sensors to the instrument first. Cord to be firmly inserted.
● Never attempt to make any measurement if any abnormal conditions, such as a broken cover or
exposed metal parts are present on the Instrument, Voltage test leads, Power cord and Clamp sensor.
- Measurement –
● Ensure that the Current input terminal cover, USB connector cover and CF card connector cover are
closed when not in use during a measurement.
- Not in use for a long period -
● Remove the Power cord from the outlet if the instrument will not be in use for a long period.
- Repair -
● Do not install substitute parts or make any modification to the instrument. Return the instrument to your
local KYORITSU distributor for repair or re-calibration in case of suspected faulty operation.
- Battery -
● Do not try to replace the batteries if the surface of the instrument is wet.
● Ensure that the Power cord, Voltage test leads and Clamp sensor are removed from the instrument,
and that the instrument is switched off when opening the Battery cover for battery replacement.
● Do not use dry-cell batteries with the Selector Switch set to “RECHARGEABLE BATTERY” position.
It may cause electrical shock accident.
● Never mix new and old batteries.
● Install batteries in correct polarity as marked inside.
- Power cord -
● Do not use the damaged cord.
● Don’t put heavy things on, step on or pinch the cord, moreover, not to touch any heating material.
● When unplugging the cord from the mains socket outlet, do so by removing the plug first and not by
pulling the Power cord.
- Measures against abnormal symptoms -
● If the instrument begins to emit smoke, becomes too hot, or gives off an unusual smell, immediately
power it off and disconnect the power cord from the outlet. Also power off the power to the object under
test. If any anomalies as noted, contact your local KYORITSU distributor.
- Use of protective gears -
● Use insulated gloves, boots or head gears at measurements to ensure user’s safety.