KYORITSU 6310 Instruction Manual - Manual (Page 51)

KEW6310 4.2.1 Basic Setting
KEW6310
4.10
3
Press the Cursor Keys and select Clamp sensors to be used at the other CH, and
make settings in the same way.
Settings for [Clamp] and [A Range] are active in subsequent measurements, but they will change
when preset wiring configurations are changed. The highest Range is applied to all Chs when the
[A Range] at each Ch should be harmonized due to a change of wiring configurations.
When setting for [Clamp] is done, the upper
limit of measuring range of the selected
sensor is displayed automatically.