KYORITSU 6310 Instruction Manual - Manual (Page 33)

KEW6310 3.2.1 Battery
KEW6310
3.6
Rechargeable batteries
This instrument can charge rechargeable batteries via AC power supply.
1 Loosen two Battery Cover-fixing screws and remove the Cover.
2 Take out all the batteries.
3 Loosen the screws and remove the Selector Switch Cover.
Attention should be paid so as not to lose the screws.
4 Slide to left and set the Selector Switch to “RE-CHARGEABLE” position.
5 Install the Selector Switch Cover with the marking of rechargeable battery faced up, and tighten the
screws.
6 Insert batteries (HR-15/51 : size AA Ni-MH rechargeable batteries) in correct polarity.
7 Install the Battery Cover and tighten two screws.
8 Connect the AC Power Cord and power on the instrument.
~ Battery charge ~
Message windows on the next page appear when starting the instrument under following conditions and with
battery level of 40% or less.
* Install rechargeable batteries (Ni-MH)
* Slide and set the Selector Switch to “RE-CHARGEABLE” position.
* Connect the AC Power cord and power on the instrument.
Refer to “4.2.4 Other Settings” and see the procedure to start battery charge any time.
9 Follow the message displayed on the LCD and press the Cursor and ENTER Keys to start
charging batteries. Selecting “No” returns to the normal screen.
Battery charge doesn’t initiate only by installing rechargeable batteries and connecting an AC power cord.
Above operation is required to start a battery charge.