KYORITSU 6310 Instruction Manual - Manual (Page 55)

KEW6310 4.2.1 Basic Setting
KEW6310
4.14
2 Press the Cursor Keys and select a Current Range to be used, and then press the
ENTER Key.
3 Press the Cursor Keys and select Clamp sensors to be used at the other Ch, and
make settings in the same way.
Settings of [Clamp] and [A Range] are active in following measurements, but they will change when
preset wiring configurations are changed. The highest Range is applied to all Chs when the
[A Range] at each Ch should be harmonized due to a change of wiring configurations.
Drop down list appears.
Selected Current Range per Ch
is displayed.
When setting for [Clamp] is done, the
upper limit of measuring range of the
selected sensor is displayed automatically.