KYORITSU 6310 Instruction Manual - Manual (Page 11)

KEW6310 Safety warnings
KEW6310
10
CAUTION
● Caution should be taken since conductors under test may be hot.
● Never apply currents or voltages exceeding the maximum allowable input for the instrument for a long time.
● Don’t apply currents or voltages to Voltage test leads or Clamp sensors while the instrument is in off status.
● Don’t use the instrument at dusty places or to be spattered.
● Don’t use the instrument under a strong electric storm or in the vicinity of energized object.
● Never give strong vibrations or drop shocks.
● Do not place or remove a CF card while CF card is being accessed. ( flashes while CF card is being
accessed.) Otherwise saved data in the card or the instrument may be damaged.
- Clamp sensor -
● Do not bend or pull the cable of the Clamp sensor.
- Treatment after use -
● Power off the instrument and disconnect the Power cord, Voltage test leads and Clamp sensors from
the
instrument.
● Remove the batteries if the instrument is to be stored and will not be in use for a long period.
● Remove the CF card when carrying the instrument.
● Never give strong vibrations or drop shocks when carrying the instrument.
● Do not expose the instrument to direct sunlight, high temperatures, humidity or dew.
● Use a damp cloth with neutral detergent for cleaning the instrument. Do not use abrasives or solvents.
● Do not store the instrument if it is wet.
Carefully read and follow the instructions: DANGER, WARNING, CAUTION and NOTE ( )
described in each section.
The following symbols are used in this manual:
User must refer to the explanations in the instruction manual.
Instrument with double or reinforced insulation, Class II insulation
~
AC
(Functional) Earth terminal