Inserting dry-cell batteries – KYORITSU 6310 Instruction Manual User Manual
Page 32
3.2.1 Battery KEW6310
3.5
KEW6310
Inserting dry-cell batteries
1 Loosen two Battery Cover-fixing screws and remove the Cover.
2 Take out all the batteries.
3 Loosen the screws and remove the Selector Switch Cover.
Attention should be paid so as not to lose the screws.
4 Slide to left and set the Selector Switch to “DRY” position.
5 Install the Selector Switch Cover with the marking of dry battery faced up, and tighten the screws.
6 Insert batteries (LR6 : size AA alkaline batteries) in correct polarity.
7 Install the Battery Cover and tighten two screws.
8 Connect the AC Power Cord and power on the instrument.
Slide and set the Selector Switch to the proper position prior to installing the Selector Switch Cover.
The instrument should be used with the Switch set to a proper position. Never make measurement without
installing the Cover.