Setting for flicker measurement, Setting for voltage range, Setting for filter – KYORITSU 6310 Instruction Manual User Manual
Page 95
KEW6310 4.2.2 Measurement Setting (QUALITY-Flicker)
KEW6310
4.54
Setting for Flicker measurement
For the details of Flicker measurement, refer to “11.6 Flicker measurement” in this manual.
Setting Items
V Range
：
select a desirable Voltage Range（150～600V）
Filter
：
select a visibility filter for flicker calculation
Output item
：
set conditions for output to Output terminal
Output Threshold
：
select a threshold value for Output terminal
Setting for voltage range
150／300／600V
* Default value (or after system reset) : 300V
* Setting procedure is same to that for Voltage Range described in the clause of “Setting for Transient
measurement“. Refer to the procedure described in the preceding pages.
Setting for Filter
Follow the procedure below and select any filter factor.
230V／120V／100V
* Default value (or after system reset) : 230V
1 Select any desirabe [Filter] with
Cursor
Key and press the
ENTER
Key.