2 getting power from measured lines – KYORITSU 6310 Instruction Manual User Manual
Page 278
14.2 Getting power from measured line KEW6310
14.3
KEW6310
14.2 Getting power from measured lines
When there is difficulties in getting power from an outlet, KEW6310 operates with powers on the
measured line by using Voltage test leads with Power supply adapter MODEL8312.
Connect the Adapter according to following procedure.
1
Confirm that the Adapter is off.
2
Connect the Plug of the Adapter to VN and V1
terminals on KEW6310/6300 and Power Plug to
the Power connector respectively.
3
Connect the Voltage test leads to VN and V1
terminals
of
the
Adapter.
4
Connect the Alligator clips of the Voltage test
leads to the circuit under test.
5 Power
on
the
Adapter.
6
Power on KEW6310/ 6300.
* Reversed procedure is applied to remove the
Adapter from KEW6310/ 6300.
Fuse rating : AC500mA/ 600V,
Fast acting, Φ6.3 x 32mm
For further details, refer to the Instruction manual for MODEL 8312.
1
2
3
4
5
6