KYORITSU 6310 Instruction Manual - Manual (Page 217)

KEW6310 11.3.2 Power quality – Measuring procedure (Transient measurement)
KEW6310
11.12
11.3.2 Measuring Procedure
Steps for measurement
Ensuring your safety See “Safety Warnings”.
↓
Getting started See “Section 3 Getting started”.
↓
Settings See “Section 4 Setting”.
↓
Wiring See “Section 5 Wiring Configuration”.
↓
Transient measurement See this section
* At Transient measurements, measured values are displayed when recording starts.
Measurement Setting Save Setting
Interval* Recording method
V Range Recording start
Threshold Recording termination
Hysteresis Destination to save data
Trigger Point
* Flicker measurement function is only available with ver.2.00 or later.