Rockwell Automation 20-COMM-D DeviceNet Adapter Series B FRN 2.xxx - Manual (Page 72)

4-30 Configuring the I/O
20-COMM-D DeviceNet Adapter User Manual
Publication 20COMM-UM002G-EN-P
13. Click AutoMap to map the drive input image to the 1771-SDN scanner
as shown in this example below.
14. Click the Output tab to display the output registers for the 1771-SDN
scanner.
Important: If your RSLogix 5 project requires a different memory
selection than the default setting for the drive output image,
set the Memory field to the appropriate setting. For this
example, the default setting of Block Xfer 62 and its
corresponding N-files are used.
15. Click AutoMap to map the drive output image to the 1771-SDN
scanner as shown in this example below.
TIP: If your RSLogix 5 project requires a different starting Word
(word, 32-bit) than the default value of 0 for the drive input image, set
the Start Word field to the appropriate value.
TIP: If your RSLogix 5 project requires a different starting Word
(word, 32-bit) than the default value of 0 for the drive output image, set
the Start Word field to the appropriate value.