Rockwell Automation 1747-L5xx SLC 500 Modular Hardware Style User Manual - Manual (Page 102)

Publication 1747-UM011G-EN-P - June 2008
102 Installing Your Hardware Components
Install Modules Follow the steps below to install your modules.
1. Align the circuit board of the module with the card guide in the
chassis.
2. Gently slide the module in until both top and bottom retainer
clips are secured.
3. Install a wire tie to secure your wiring and keep it neat. (If you
feed the tie into one hole, it will be routed back out through the
other.)
4. Cover any unused slots with card slot fillers (catalog number
1746-N2) to keep the chassis free from debris and dust.
5. To remove the module, press the retaining clips at the top and
bottom of the module and slide the module out.
Retainer Clip
Retainer Clip
Side View