Rockwell Automation 1747-L5xx SLC 500 Modular Hardware Style User Manual - Manual (Page 120)

Publication 1747-UM011G-EN-P - June 2008
120 Wiring Your I/O Modules
Install the RTB
Below are guidelines for installing the RTB.
1. Be sure the color of the RTB matches the color band on the
module.
2. Write the appropriate slot, chassis, and module type on the RTB
label.
3. Disconnect power.
4. Align the terminal block release screws with the mating
connector in the module.
5. Press the RTB firmly onto the connector contacts.
6. Tighten the terminal block release screws. To avoid cracking the
terminal block, alternate the tightening of the screws.
ATTENTION
Inserting a wired RTB on an incorrect module can
damage the module circuitry when power is applied.
ATTENTION
Disconnect power before attempting to install or remove
I/O modules or their terminal blocks.
Terminal Block Release Screws
Maximum Torque:
0.9 Nm (8 lb-in)