Rockwell Automation 1747-L5xx SLC 500 Modular Hardware Style User Manual - Manual (Page 105)

Publication 1747-UM011G-EN-P - June 2008
Installing Your Hardware Components 105
Perform this procedure to install the power supply.
1. Align the circuit board with the card guide on the left side of the
chassis. Slide the power supply in until it is flush with the
chassis.
2. Fasten the power supply to the chassis with the two Phillips
head screws.
3. Place the jumper to match the input voltage. (This does not
apply to 1746-P3, 1746-P5, 1746-P6, or 1746-P7 power supply
which do not have a jumper.)
1.2 Nm (11 lb-in)
maximum torque
ATTENTION
Make jumper selection before applying power.
Hazardous voltage is present on exposed pins when
power is applied.