Rockwell Automation 1747-L5xx SLC 500 Modular Hardware Style User Manual - Manual (Page 44)

Publication 1747-UM011G-EN-P - June 2008
44 Selecting Your Hardware Components
programmer. The 1747-M15 Series B adapter socket is required for
use with the memory module (catalog number 1747-M13).
See the table below for details on the Flash EPROM and adapter
socket.
To program a memory module, refer to your programming software
user manual or help resource. Follow this procedure to program a
memory module.
1. Set the memory module configuration bits (S:1/10 to S:1/12) in
your offline program file. Refer to SLC 500 Instruction Set
Reference Manual, publication 1747-RM001, for details on the
Memory Module Configuration Bits.
2. Download your program file to your processor.
3. Go online with the processor and burn the program to the
EEPROM memory module (per the instructions outlined in your
programming software user manual or help resource).
EEPROM Burning Options You can burn a program into an EEPROM memory module using a
processor that is the same or different from the one used to run the
program. When burning EEPROMs, keep the following conditions in
mind:
• The processor burning the EEPROM must be of the same type
and have the same OS version or lower than the target
processor.
ATTENTION
Make sure the adapter is inserted properly in the programming
equipment or damage could result.
Memory Module Compatibility
Cat. No. Description
Use with this processor type
SLC 5/03 SLC 5/04 SLC 5/05
1747-L531, 1747-L532,
1747-L533 1747-L541, 1747-L542,
1747-L543 1747-L551, 1747-L552,
1747-L553
1747-M13 Supports up to 64 K of user-memory backup X
(Series C
OS302 or later)
X
(Series C
OS401 or later)
X
(Series C
OS501 or later)