Rockwell Automation 1771-QDC, D17716.5.86(Passport) PLASTIC MOLDING MODULE - Manual (Page 159)

Span Your Valves
Chapter 9
9-2
The following table lists command blocks used in this chapter and in
corresponding worksheets from chapters 7 and 8 that contain initial values.
Block: Worksheet:
Clamp Close Profile Block (CPC) 8ĆA
Clamp Open Profile Block (OPC) 8ĆE
First Clamp Close Configuration Block (FCC) 7ĆA
Second Clamp Close Configuration Block (SCC) 7ĆB
Third Clamp Close Configuration Block (TCC) 7ĆC
Clamp Low Pressure Close Configuration Block (LPC) 7ĆD
First Clamp Open Configuration Block (FOC)
7ĆI
Second Clamp Open Configuration Block (SOC) 7ĆJ
Third Clamp Open Configuration Block (TOC) 7ĆK
Clamp Open Slow Configuration Block (OSC) 7ĆL
Injection Configuration Block (INC) 7ĆE
Injection Profile Block (IPC) 8ĆB
Pack Configuration Block (PKC) 7ĆF
Hold Configuration Block (HDC) 7ĆG
Pack/Hold Profile Block (HPC) 8ĆC
Plastication Configuration Block (PLC) 7ĆH
Plastication Profile Block (PPC) 8ĆD
ATTENTION: As with any machine start-up, install a test
mold. Programming errors, configuration errors, or hydraulic
problems could lead to machine damage or injury to personnel.
ATTENTION: Make sure all machine guards and shields are in
place before proceeding.
Important: Maintain the same initialization values that you entered in
previous chapters except where noted in the text.
Referenced Worksheets