Rockwell Automation 1771-QDC, D17716.5.86(Passport) PLASTIC MOLDING MODULE - Manual (Page 75)

Select Command and Status Bits
to Sequence Machine Operation
Chapter 6
6-4
Table 6.D
Command Bits To Interrupt Inject and Clamp Movement Between Profiles
Bit Description: QDC Block Addr.:
0 = start 2nd clamp close profile @ endĆof 1st
1 = stop and setĆoutput @ endĆof 1st
CPC03ĆB08
0 = start 3rd clamp close profile @ endĆof 2nd
1 = stop and setĆoutput @ endĆof 2nd
CPC03ĆB09
0 = start LP close profile @ endĆof 3rd
1 = stop and setĆoutput @ endĆof 3rd
CPC03ĆB10
0 = start 2nd clamp open profile @ endĆof 1st
1 = stop and setĆoutput @ endĆof 1st
OPC03ĆB08
0 = start 3rd clamp open profile @ endĆof 2nd
1 = stop and setĆoutput @ endĆof 2nd
OPC03ĆB09
0 = start clamp open slow profile @ endĆof 3rd
1 = stop and setĆoutput @ endĆof 3rd
OPC03ĆB10
0 = start preĆdecompression movement @ endĆof hold
1 = stop and set output @ endĆof hold
HPC03ĆB08
0 = start plastication profile @ endĆof preĆdecompression
1 = stop and set output @ endĆof preĆdecompression
HPC03ĆB09
0 = start postĆdecompression movement @ endĆof plastication
1 = stop and set output @ endĆof plastication
PPC03ĆB08