Rockwell Automation 1771-QDC, D17716.5.86(Passport) PLASTIC MOLDING MODULE - Manual (Page 42)

Configure the QDC Module's I/O
Chapter 3
3-4
Table 3.A
Determine Initial SensorĆconfiguration Values for Worksheet 3ĆD
Category: If your: Then Use a Value Equal to:
Minimum Position
(Lines 1 and 9)
N/A zero
Maximum Position
(Lines 2 and 10)
ram (screw) is fully extended to the
mold end (ram bottom), and the
mold closed position is zero.
maximum range value specified by the
manufacturer (full travel of the sensor
Analog Signal @ Min Position sensor is forwardĆacting low end of your selected range
(Lines 3 and 11) sensor is reverseĆacting high end of your selected range
Analog Signal @ Max Position sensor is forwardĆacting high end of your selected range
(Lines 4 and 12) sensor is reverseĆacting low end of your selected range
Minimum Pressure
(Lines 5 and 13)
N/A minimum range value specified by the
manufacturer
Maximum Pressure
(Lines 6 and 14)
N/A maximum range value specified by
manufacturer
Analog Signal @ Min Pressure sensors are forwardĆacting low end of your selected range
(Lines 7 and 15) sensors are reverseĆacting high end of your selected range
Analog Signal @ Max Pressure sensors are forwardĆacting high end of your selected range
(Lines 8 and 16) sensors are reverseĆacting low end of your selected range