Rockwell Automation 1771-QDC, D17716.5.86(Passport) PLASTIC MOLDING MODULE - Manual (Page 27)

Chapter
2
2-1
Install the QDC Module
This chapter guides you through the following procedures:
record I/O ranges
set module jumper plugs
key your I/O chassis
install the QDC module
wire the QDC module
ground your system
plan for E-STOPs and machine interlocks
To match your QDC module to your I/O devices, record the I/O ranges of
your I/O devices on Worksheet 2-A. You will use this information in this
chapter for hardware configuration (setting jumper plugs) and in chapter 4
to configure the module’s inputs and outputs with software.
Circle or check the I/O ranges on Worksheet 2-A. Cross off I/O not used.
Worksheet 2ĆA
Record I/O Ranges
I/O Connection: Voltage 1: Voltage 2: Current:
Input 1 (Screw position) 0 to 10 Vdc 1 to 5 Vdc 4 to 20 mA
Input 2 (Screw pressure) 0 to 10 Vdc 1 to 5 Vdc 4 to 20 mA
Input 3 (Clamp position) 0 to 10 Vdc 1 to 5 Vdc 4 to 20 mA
Input 4 (Clamp pressure) 0 to 10 Vdc 1 to 5 Vdc 4 to 20 mA
Output 1 Ć10 to 10 Vdc 0 to 10 Vdc 4 to 20 mA
Output 2 Ć10 to 10 Vdc 0 to 10 Vdc 4 to 20 mA
Output 3 Ć10 to 10 Vdc 0 to 10 Vdc 4 to 20 mA
Output 4 Ć10 to 10 Vdc 0 to 10 Vdc 4 to 20 mA
Chapter Objectives
Record I/O Ranges