Rockwell Automation 1771-QDC, D17716.5.86(Passport) PLASTIC MOLDING MODULE - Manual (Page 83)

Load Initial Configuration Values
Chapter 7
7-2
The following table lists command blocks and corresponding worksheets
for recording your initial values that you use to configure the QDC
module.
To configure the QDC module with this configuration
block:
Use this Worksheet: On page:
First Clamp Close Configuration Command Block (FCC)
Worksheet 7-A 7-4
Second Clamp Close Configuration Command Block (SCC) Worksheet 7-B 7-6
Third Clamp Close Configuration Command Block (TCC)
Worksheet 7-C 7-8
Low Pressure Close Configuration Command Block (LPC) Worksheet 7-D 7-10
Injection Configuration Command Block (INC) Worksheet 7-E 7-12
Pack Configuration Command Block (PKC) Worksheet 7-F 7-14
Hold Configuration Command Block (HDC) Worksheet 7-G 7-16
Plastication Configuration Command Block (PLC) Worksheet 7-H 7-18
First Clamp Open Configuration Command Block (FOC) Worksheet 7-I 7-20
Second Clamp Open Configuration Command Block (SOC)
Worksheet 7-J 7-22
Third Clamp Open Configuration Command Block (TOC) Worksheet 7-K 7-24
Clamp Open Slow Configuration Command Block (OSC) Worksheet 7-L 7-26
Important: We omitted pre- and post-decompression blocks because you
do not use them when spanning valves in chapter 9. We discuss their
application in chapter 10.
Take a moment now to browse through the worksheets.
Notice that each worksheet contains two parts:
control words for selecting parameters by setting bits
a configuration block of data words for recording initial values
Also notice that many parameters repeat from one block to the next. For
example:
control bits for selecting an output
block parameters such as decel ramp rate during profile
Because of this, we describe how you determine an initial value once for
all configuration blocks that require it. Then you enter that parameter in
all applicable configuration blocks. That is why we grouped all
worksheets together, followed by all text.
Use These Worksheets