Jog your machine chapter 5 – Rockwell Automation 1771-QDC, D17716.5.86(Passport) PLASTIC MOLDING MODULE User Manual
Page 69
Enter Your Initial Values Here
Jog Your Machine
Chapter 5
5-8
Worksheet 5. B
ScrewĆrotate & Eject Jog Configuration Values for Indirect Control
Control Block
Word
ProĆSet 600 Addr. Value
Description
Units
Screw Rotate Jog
JGC09
N40:65
Set Output Values Output #1
% Signal Output
1
JGC10
N40:66
Output #2
% Signal Output
1
JGC11
N40:67
Output #3
% Signal Output
1
JGC12
N40:68
Output #4
% Signal Output
1
Ejector, Advance Jog
JGC49
N40:105
Set Output Values Output #1
% Signal Output
1
JGC50
N40:106
Output #2
% Signal Output
1
JGC51
N40:107
Output #3
% Signal Output
1
JGC52
N40:108
Output #4
% Signal Output
1
Ejector, Retract Jog
JGC57
N40:113
Set Output Values Output #1
% Signal Output
1
JGC58
N40:114
Output #2
% Signal Output
1
JGC59
N40:115
Output #3
% Signal Output
1
JGC60
N40:116
Output #4
% Signal Output
1
1
% Signal Output
00.00 to 99.99 %
If your hydraulics require it, take time now to develop ladder logic
(independent of Pro-Set 600 software) so the QDC module (in inject and
clamp mode) can assist in screw-rotate and ejector jogs. Otherwise, omit
the rest of this chapter.
Use word 1 in the dynamic command block (DYC01) to enable and disable
individual jogs. Use word 1 in the system status block (SYS01) to monitor
the QDC module’s reaction to jog commands. Tables 5.C and 5.D identify
command and status bits for jogging screw rotation and/or the ejector.
Write Ladder Logic to Assist
with ScrewĆrotate and
Ejector Jogs