Rockwell Automation 1771-QDC, D17716.5.86(Passport) PLASTIC MOLDING MODULE User Manual
Page 70
Jog Your Machine
Chapter 5
5-9
Table 5.C
Enable Bits for ScrewĆrotate and Ejector Jogs
Command Block Word: ProĆSet 600 Address: Description:
DYC01ĆB09
B34/393
Execute ScrewĆrotate Jog
DYC01ĆB14
B34/398
Execute Ejector Jog Advance
DYC01ĆB15
B34/399
Execute Ejector Jog Retract
Table 5.D
Status Bits for ScrewĆrotate and Ejector Jogs
Status Block Word: ProĆSet 600
Address:
Description:
SYS01ĆB09
B34/9
ScrewĆrotate Jog in Progress
SYS01ĆB14
B34/14
Ejector Jog Advance in Progress
SYS01ĆB15
B34/15
Ejector Jog Retract in Progress
We provide a programming example (Figure 5.2) of assisted jog control for
instructional purposes only. Your application-specific programming may
vary significantly from this example.
Important: You may also need to develop ladder logic that changes the
direction of ejector travel hydraulically when you command the QDC
module to retract the ejector.