Rockwell Automation 1760-DNET Pico DeviceNet Communications Module User Manual - Manual (Page 14)

Publication 1760-UM003A-EN-P - September 2005
2-2 Installation
Connect the Power Supply The module operates with a 24V dc supply voltage (see Power Supply
specifications on page A-3).
Connect DeviceNet A 5-pin DeviceNet plug connects the DeviceNet interface of the
device to the DeviceNet field bus.
Use a special DeviceNet plug and DeviceNet cable for this connection.
Both are specified in the ODVA specification. The type of cable
determines the maximum available cable length and the data transfer
rate.
DeviceNet Pin Assignment
WARNING
Always ensure safe electrical isolation between the
extra low voltage (SELV) and the 24V power supply.
+24 V
> 1 A
0 V
+24 V 0 V
1
2
3
4
5
1
2
3
4
5
V– GND (Black)
CAN_L (Blue)
Shield (Clear)
CAN_H (White)
V+ (24 V) (Red)