Rockwell Automation 1760-DNET Pico DeviceNet Communications Module User Manual - Manual (Page 21)

Publication 1760-UM003A-EN-P - September 2005
Operate the DeviceNet Interface 3-3
7. Press OK to accept the address.
8. Press ESC to cancel address input.
Information about the 4th display line:
Set the Address with Pico-SOFT
With Pico-SOFT, version 3.1
‹Menu l Online l Configuration of expansion units›
With Pico-SOFT, version 4.01 and later
‹Menu l Communication l Configuration l Expansion units l
1760-DNET›.
Set the Address with the DeviceNet Master
The configuration software supplied with your master programmable
controller offers the option of setting or modifying the MAC ID of the
gateway.
xxx - xx . xx - xx
222 - 02. 10 - B
Hardware version, Index: b
Software version, OS version: 2.1
Device identity: 1760-DNET
IMPORTANT
The menu is only available in the communication
view; therefore please activate the ‘Communication’
tab.
IMPORTANT
After you have modified the MAC ID via the basic
unit, restart the DeviceNet Interface by switching
power off and on.