Fluke Biomedical SigmaPace 1000 - Manual (Page 136)

SigmaPace 1000
Operators Manual
5-6
ERR=03
Illegal parameter. A parameter sent as part of the command was not the
correct type or was out of range; or, it contained an incorrect number of
parameters.
Transcutaneous Pacemaker Remote Setup and
Testing
The following commands are associated with setting up and testing a
transcutaneous pacemaker in remote mode.
SETMODE
SETMODE=TQPACE
Selects the Analyzer’s transcutaneous pacer test mode of operation.
Note
All subsequent serial port communications must relate to
transcutaneous pacer features and follow the prescribed
measurement protocols listed below.