Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 125)

Appendix B: Mariner™ & Voyager II™ 113
Key Logging
The Key Logging feature is used to record key press and other related information in a daily log file.
This is intended for use by Service Technicians when a fault occurs to help review events prior to the
fault experienced. When enabled, the file will be saved to the hard drive then may be retrieved
through the Files feature by transferring the file to floppy diskette. Generally, this parameter is set to
NO unless instructed by a technician to be enabled.
THCs Installed
The THC Installed parameter defines the total number of Sensor™ THC axes assigned for operation
at the control.
THC Installed On Axis / Analog
This setup parameter is used to define the THC axis for use. The user can select which axis the THC
is to be commanded on, the analog input to use ( arc voltage feedback ) and which plasma.
Note: Refer to the Station Configuration and Sensor™ THC sections of this guide for additional
information on the setup and use of the Sensor™ THC.
Speeds
The following Speeds setup parameter will be available when Tilt Rotator has been enabled.