Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 158)

146 Installation & Setup Guide
ESSI Comments
Comments may be placed in to the part program to be displayed on screen and viewed by the
operator. The comment line must first be preceded by a program stop command (EIA M00 code or
ESSI 0 code).
ESSI Example:
0 – Pauses Program
3 – Start Comment
Comment – Text to be displayed
4 – End Comment
Unique Feature Codes
Kerf Table
Code Description
G59 D1-200Xvalue Sets kerf table variable from 1-200
G41 D1-200
Enables Left Kerf using a Kerf Table variable
G42 D1-200 Enables Right Kerf using a Kerf Table variable
G43 D1-200 Changes current kerf value via Kerf Table using previously set Left or Right
kerf
Tilt / Rotator Part Codes
Code Description
G00 Avalue
Sets Tilt angle as a preparatory command – A is the angle value in degrees
G00 XYvalue Avalue Performs Linear Interpolation of Tilt angle along line segment.
G00 Avalue Fvalue
Sets Tilt angle – Angle value in degrees with a speed command in RPM
M28 Disables Follower
M29 Enables Follower
M90 Preparatory Cmd - Aligns Rotator to Tangent angle of next cut segment
M75 A axis/Tilt Goto Home Cmd - Rapid Index
Automatic Torch Spacing Program Codes
Code Description
M32 Unclamp / Unlock All Stations
M33 Unclamp / Lock All Stations
M34 Clamp / Unlock All Stations
M34Tvalue Clamp / Unlock ‘T” Station, where T = 1 through 19
M35 Clamp / Unlock All Stations Mirror
M35Tvalue Clamp / Unlock Mirror “T” Station, where T = 1 through 19
M77 Go to Home position Y Axis
M78 Go to Home position X Axis