Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 95)

Section 4: Password Setups 83
Format Floppy Disk
Pressing the Format Floppy Disk softkey will format a floppy disk placed into the floppy drive. This is
advantageous in the event that the control has difficulty reading a floppy disk formatted by a
computer. Note: Formatting the diskette will remove any files that are stored on the diskette.
Reset Setups
Reset Setups will delete the current setup file, forcing default values to be loaded. A new setup file
can then be loaded on the control through the Special Password screen.
If the control supplier has installed a customized setup file containing information specific to the
cutting table, the Reset Setups Softkey is renamed Restore Setups. This custom setup file then
becomes the new default setup file and pressing the Restore Setup Key will return the control to the
original factory settings, as configured by the control supplier.