Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 200)

188 Installation & Setup Guide
I/O Connector J6
Pin Description Default
I/O Description
1 Input 17 Gas Control Read Complete
2 Input 18 Gas Control Error
3 Input 19 Raise Torch 1
4 Input 20 Lower Torch 1
5 Input 21 Enable THC 1
6 Input 22 Raise Torch 2
7 Input 23 Lower Torch 2
8 Input 24 Enable THC 2
9 Input 25 Spare
10 Input 26 Spare
11 Input 27 Spare
12 Input 28 Spare
13 Input 29 Spare
14 Input 30 Spare
15 Input 31 Spare
16 Input 32 Spare
17 +24 VDC N/A
18 +24 VDC N/A
19 Chassis Ground N/A
20 Output 17 Remote Air Plasma
21 Output 18 Remote H35/N2 Plasma
22 Output 19 Remote O2 Plasma
23 Output 20 Gas Flow Set 1
24 Output 21 Gas Flow Set 2
25 Output 22 Gas Flow Set 4
26 Output 23 Gas Flow Set 8
27 Output 24 Gas Flow Set 10
28 Output 25 Gas Flow Set 20
29 Output 26 Gas Flow Set 40
30 Output 27 Gas Flow Set 80
31 Output 28 Gas Flow Set 100
32 Output 29 Valve Select 1
33 Output 30 Valve Select 2
34 Output 31 Valve Select 4
35 Output 32 Valve Select 8
36 +24 VDC Common
37 +24 VDC Common
Mating Connector
Connector: 37C D-Sub Amp # 205210-3 or equivalent
Backshell: Amp #748676-4 or equivalent
Pins: Amp #5-66507-9 ( 24-28 AWG ) or equivalent
Note: Additional I/O for the Voyager II™ will be available through use of optional Analog Input cards.
Additional information on the Optional Analog Input Cards is available in the Sensor™ THC section of
this guide.
Please contact your control vendor for more information on how the Analog Input Card may be
configured in your control.