I/o interface – Hypertherm HTA Rev 6.00 Install Guide User Manual
Page 240
228
Installation & Setup Guide
I/O Interface
Series 1 ISA Analog Card
Pin # Description
1 Joystick
Up
2 Joystick
Down
3 Joystick
Left
4 Joystick
Right
5 E-Ground
6 No
Connection
7 No
Connection
8 No
Connection
9 No
Connection
Note: Joystick inputs are activated by passing the Common signal ( pin 5 ) to the desired input.
Analog inputs for the speedpots are rated at 0 - +10VDC
Joystick Mating Connectors
Connector AMP #206708-1
Backshell AMP #206966-1
Sockets (20-24 ga) AMP #66105-3
Cabling: Use CAROL #C0603 or equivalent
Series 1 PCI Analog Card
Pin #
Designation
Description
1
Input 1
Joystick UP
2 Input
2
Joystick
DWN
3
Input 3
Joystick LT
4 Input
4
Joystick
RT
5 Common
Common
6
Analog Input 3 +
Speed Pot 1
7
Analog Input 3 –
Speed Pot 1
8
Analog Input 4 +
Speed Pot 2
9
Analog Input 4 –
Speed Pot 2
Ground Stud
Shield
Note: Joystick inputs are activated by passing the Common signal ( pin 5 ) to the desired input.
Analog inputs for the speedpots are rated at 0 - +10VDC
Mating Connector
Connector AMP #206708-1
Backshell AMP #206966-1
Sockets (20-24 ga) AMP #66105-3
Cabling: Use Belden # 9504 or equivalent
THC and Joystick Cable Grounding
Cable shields should be tied to the external PE studs for optimum noise immunity.