Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 83)

Section 4: Password Setups 71
Example: If Station 1 has been defined as having a Sensor™ THC and a MAX200 ® for Plasma
Process 1, no other power supply type can be selected for Plasma Process 1. However, MAX200 ®
for Plasma Process 1 may be select at other stations if a Sensor THC has been selected.
Command
® THC Support
Selecting a Command THC as the lifter for a process enables the serial Link to be assigned for a
single Command
® THC. Note: The actual serial port must be assigned on the Ports setup screen.
This also configures the selected Plasma / Marker Cut Types screen to display the Command ® THC
features. If a Command ® THC has been selected for a station but does not use the serial
communication feature to the control, then the Lifter type should be set to “Other”.
Please refer to the Command
® THC section of this manual for additional information on the operation
of the Command ® THC
HD4070
® Support
The HD4070 ® feature establishes the Serial Link HD4070 ® Power Supply communication link and
configures the selected Plasma / Marker Cut Types screen to display the HD4070 ® features. A single
HD4070 ® must be assigned to Stations 1 & 2. A second multi-dropped HD4070 may be assigned on
stations 3 & 4.
Each HD4070
® has the ability to use two Integrated Command ® THCs. These are controlled by the
HD4070 ® and as such have designated Station locations.