Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 84)

72 Installation & Setup Guide
In the previous example, you can see that the Cutting and Marking with the HD4070
® Integrated
Torch 1 is limited to Plasma Process 1 / Maker Process 1 on Station 1. Additionally, the Cutting and
Marking with HD4070
® Integrated Torch 2 is limited to Plasma Process 2 / Maker Process 2 on
Station 2. These stations may be configured to Cut or Mark or both. A second multi-dropped
HD4070 may be also be assigned on stations 3 & 4.
FineLine 100 / 200 Support
Serial communications to INNERLOGIC’s FineLine 100 and FineLine 200 may be enabled and
configured for use with selected THCs.