Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 88)

76 Installation & Setup Guide
Zero Positions
This parameter determines whether the control operator has the ability to zero positions. When
disabled, the zero positions softkey will be grayed out and will be unavailable to the operator.
Auto Size App.
When enabled, the Auto Size App. feature is used for the demo software to size the application
software to full screen display or the standard size of 640x480 (disabled).
Language
The language selection parameter allows the user to select the language displayed on the control
from the available languages stored on the control. Languages may be added to the control by
performing the standard software update with a language specific update file. Eastern languages
may also require the installation of a font viewer to properly display the required characters. To
change to a different language, select the desired language and press the DONE softkey. You will
then be prompted to cycle power on the control for the new language to be displayed.
Password
The password parameter allows the user to enter a new password for machine setups. Numbers or
letters may be used.
Special Password
The password parameter allows the user to enter a new password for special setups. Numbers or
letters may be used.
Station Configuration Password
The password parameter allows the user to enter a new password for Station Configuration setups.
Numbers or letters may be used.
Auto Update Max Consumable Life
When enabled, this feature will continue to track the consumable life values beyond the user defined
set point and assign that maximum values as the new set point. If disabled, the user defined set point
for maximum consumable life will not be updated.
Machine Position Resets
When enabled, the Machine Position Resets feature will reset the absolute machine position when
the Zero Positions softkey is pressed. When disabled, pressing the Zero Positions softkey will not
reset the absolute machine position. Position information based on homing will not be lost. Only the
current incremental motion ( part ) position will be reset to zero.
Auto Gas Control
When enabled, this feature allows the control to communicate with the Auto Gas Console for the
HD3070
® and allows access to the related setup parameters.
Arc Speed Limit Check
This feature allows the user the ability to turn off the Speed Limit Check performed by Softmotion for
arcs larger than 10”. This may be used to compensate for abrupt motion commands caused by non-
tangent line arc segments, smoothing out motion.