Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 131)

Appendix B: Mariner™ & Voyager II™ 119
HD3070 ® Auto Gas Interface
This section outlines information specific to the HD3070 ® Auto Gas Interface. The Auto Gas screen
is available from the Cut Types screen.
Note: The Auto Gas feature must first be enabled at the Special Password screen.
The top of the Auto Gas screen lists the valve parameter settings for the HD3070
® . Valve settings for
the 3070 ® Auto Gas console are documented in the HD3070 ® manual. When the values are set,
these become the current setting and the operator can choose to save the file to the diskette or hard
drive.
The settings at the supply are updated at control power up, whenever the settings are changed at this
screen or through commands in a part program. Supply settings are also updated if power is lost and
re-enabled at the power supply. There may be a brief delay as these power supply settings are
communicated from the control to the power supply.
Save Data
Pressing the Save Data softkey will allow the operator to save the current Autogases setting to
diskette or hard drive for future use.
Load Data
Pressing the Load Data softkey will allow the operator to Load stored Autogases setting from diskette
or hard drive for use.