Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 136)

124 Installation & Setup Guide
HPR130 Diagnostics
Remote Tools
While in the Diagnostics screen, you may press the Purple Shift Key to access remote tools.
Test Preflow
Pressing the Test Preflow Softkey performs the Test Preflow Gases feature at the power supply. This
feature is used to set the inlet gas pressures under normal flow conditions to the recommended level.
Test Cutflow
Pressing the Test Cutflow softkey performs the Test Cutflow Gases feature at the power supply. This
feature is used to set the inlet gas pressures under normal flow conditions to the recommended level.
Test HPR Gas Console
This feature provides automated test features for the HPR AutoGas console. Please contact an
authorized service agent for use of these tests.
Test Pump
Pressing the Test Pump softkey performs the Test Coolant Pump feature at the power supply. This
feature is useful in purging the air bubbles from the coolant loop after installation or repair.
Update Software
Pressing the Update Software softkey will initiate the process of the Software Update at the power
supply. Step by step instructions will be displayed on screen to guide the user through the update
process.