Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 42)

30 Installation & Setup Guide
RECO I/O at Address 50
This parameter is set to Yes if the Indramat RECO I/O module is being used to expand the total
number of I/O being used on the fiber optic ring. Note: The RECO I/O will populate the general
purpose I/O (both analog and digital) following all drive I/O.
HPR/4070 at address 60
This parameter is set to Yes if the optional SERCOS interface for HPR/4070 is being used.
HTA I/O at Address 70
This parameter is set to Yes if the optional Hypertherm SERCOS interface card is being used.