Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 130)

118 Installation & Setup Guide
Laser
Cut Chart
A cut chart database allows the user to select factory recommended settings or amend the database
for personalized settings. The Cut Chart information may be saved or loaded via the hard drive or
floppy drive. The Cut Chart files containing the factory recommended settings are available from
Hypertherm
® .
Access to the Cut Chart data is available from the Laser Cut Types screen using the shift key, as
indicated below. The laser parameters must first be enabled in the password protected Station
Configuration setups to allow the Cut Chart Information for the Laser to be available for use.
Please refer to the control Operator’s Guide for additional information on setup and use of the Laser
Cut Chart.