Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 38)

26 Installation & Setup Guide
Retrieving an Image File
Place the Norton Diskette into the control and turn the unit on. Norton Ghost will progress as follows.
“Starting PC DOS.......”
Current Copyright information will be displayed
“Select 1 to make a New Backup Image or 2 to restore existing [1,2]”
Press 2 to retrieve the back up image. Up to three custom images may be created. They are created
as “newest” to “oldest” image. The “original” ghost image is the factory default. The next message
allows the user to select which version to use when restoring.
“1. Newest.gho”
“2. Older.gho”
“3. Oldest.gho”
“4. Original.gho”
“Select the Number of the Image to restore from the choices above [1,2,3.4 ]”
Press the number for the desired image.
“--------------------------------Restoring, Please Wait --------------------------------“
Norton Ghost will launch as above indicating restore progress. The following Message will appear
when complete.
“--------------------End Restoring, Please Remove Disk and Reboot -----------------------“
Remove the diskette. Turn the control Off and then On. Table setups and software updates may
need to be reloaded if the image is not current.