Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 194)

182 Installation & Setup Guide
THC and Joystick Interface
I/O Configuration Type “P” controls have dedicated connectors for THC 1, THC and Joystick /
Speedpots.
Series 1 PCI Analog Card
Note: The Analog Card will be designated as PCI-AIC Rev A in the Control Information Diagnostic
screen.
Board Marking PCI Analog 1 Part # PCBS-0074
THC 1
Pin #
Designation Description
1 Common Common
2 Input 5 + Nozzle Contact Sense + ( Relay Contact )
3 Input 5 – Nozzle Contact Sense - ( Relay Contact )
4 Output 1 + Nozzle Contact Enable + ( Relay Contact )
5 Output 1 – Nozzle Contact Enable - ( Relay Contact )
6 Analog Input 1 + THC +
7 Analog Input 1 – THC –
8 Output 2 + Hold Ignition ( Relay Contact )
9 Output 2 – Hold Ignition ( Relay Contact )
Ground Stud Shield
Mating Connector
Connector AMP #206708-1
Backshell AMP #206966-1
Sockets (20-24 ga) AMP #66105-3
Cabling: Use Belden # 9504 or equivalent
THC 2
Pin #
Designation Description
1 Common Common
2 Input 6 + Nozzle Contact Sense + ( Relay Contact )
3 Input 6 – Nozzle Contact Sense – ( Relay Contact )
4 Output 3 + Nozzle Contact Enable + ( Relay Contact )
5 Output 3 – Nozzle Contact Enable – ( Relay Contact )
6 Analog Input 2 + THC +
7 Analog Input 2 – THC –
8 Output 4 + Hold Ignition ( Relay Contact )
9 Output 4 – Hold Ignition ( Relay Contact )
Ground Stud Shield
Mating Connector
Connector AMP #206708-1
Backshell AMP #206966-1
Sockets (20-24 ga) AMP #66105-3
Cabling: Use Belden # 9504 or equivalent