Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 144)

132 Installation & Setup Guide
Notes:
-
Please refer to the power supply operators manual for complete information on the operation and
setup of the FineLine Power Supply.
- The FineLine Power Supply parameters must first be enabled in the password protected Station
Configuration Screen to allow the Cut Chart Information for the FineLine to be available for use.
- Serial communications for the FineLine Power supply are established on the user selected
communication port. The port must be configured for RS-422 operation.
- Cut Chart Setup through part program codes is supported. Refer to Part Programming section of
the Installation Guide.