Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 19)

Section 3: Diagnostics 7
Section 3: Diagnostics
Control Information
Shows the current software versions and hardware configuration of the control. This information is
required when contacting the factory for support. Below is a typical control information screen.
Hardware
The Hardware section shows the current hardware configuration which includes the Processor Type,
Processor Speed, Memory Installed, Hard Drive Size, Hard Drive Free Space and Motion Control
Card revision.
Software Versions
The Software Versions section shows the current version of the Control’s Operating System,
Operator Interface (software version), Virtual Device Driver and the Motion Control Card software.