Hypertherm HPR260 Manual Gas Preventive Maintenance Program Rev.5 - Manual (Page 253)

APPENDIX B – CNC INTERFACE PROTOCOL
b-8 HPR260 Auto Gas Instruction Manual
Command table (3 of 13)
ID Command System Description
068 SYSTEM_RESET Manual gas system
Auto gas system Clear error conditions and resume operation. Only accepted
if system is in a shutdown error condition (Error code > 79
and State = 14).
Data:
None
Return value:
1 = accepted, 0 = not accepted
Sample:
>0689E<
>0681CF<
070 SET_CORNER_CURRENT Manual gas system
Auto gas system When CORNER CURRENT input is activated the power
supply will switch to the current percentage specified.
Data:
% of cutting current (50-100%)
50=50%
Return value:
% achieved
Sample:
>0707503<
>070007563< (set 75%)<
071 MANUAL_PUMP_CONTROL Manual gas system
Auto gas system Used to override software control of the coolant pump. If the
system has a fatal error, the pump cannot be overridden.
Data:
1 = override software to force pump on, 0 = system software
controls the pump, override off
Return value:
1 = accepted, 0 = not accepted
Sample:
>0711C9<
>0711C9<
072 GET_CONTROL_VOLTAGE Manual gas system
Auto gas system Returns the internal control voltage of the power supply
Data:
None
Return value:
Voltage (1/10 V)
1200 = 120.0 V
Sample:
>07299<
>07212005C< (120.0 volts)
5