Hypertherm HPR260 Manual Gas Preventive Maintenance Program Rev.5 - Manual (Page 259)

APPENDIX B – CNC INTERFACE PROTOCOL
b-14 HPR260 Auto Gas Instruction Manual
Command table (9 of 13)
ID Command System Description
102 SET_GAS_IO_FROM_PS Manual gas system
Auto gas system This command will allow the user to turn on or off each output of
the processor. After sending this command, the
SYSTEM_RESET command must be issued to restore the
processor state. The I/O are in the following order:
Data:
1 = On, 0 = Off for each I/O point
Return value:
1 = accepted, 0 = not accepted
Manual Gas Console
Shield cutflow
(SV16)
Calibrate bypass (SV13)
Plasma cutflow 1 (SV14)
Ramp-down valve (SV20)
Shield preflow
(SV17)
Plasma preflow (SV18)
Plasma cutflow 2 (SV 19)
H35 plasma cutflow 2
(SV12)
Spare valve (SV15)
O2 shield cutflow (SV4)
Air shield cutflow (SV5)
N2 shield cutflow (SV6)
Air preflow
(SV7)
N2 preflow (SV8)
Air plasma cutflow 2 (SV9)
Air plasma cutflow 1 (SV1)
O2 plasma cutflow 1 (SV2)
H35 plasma cutflow 1 (SV3)
O2 plasma cutflow 2 (SV10)
N2 plasma cutflow(SV11)
Auto Gas Console
O2 inlet
(SV1)
Air inlet (SV2)
Air inlet 2 (SV3)
H5 inlet (SV4)
H35 inlet (SV5)
F5 inlet (SV6)
Spare out 1 (Spare)
Ramp-down valve (SV16)
Spare out 2
(Spare)
Gas 2 no mix (SV14)
Gas 2 mix (SV13)
N2 mix (SV12)
N2 inlet 2 (SV11)
Air inlet 3 (SV10)
N2 inlet (SV9)
O2 air inlet (SV8)
CH4 inlet (SV7)
Sample:
>1021111111111111111111167<
>1021C4<
5