Niveo Professional NGSME16T2H - Manual (Page 176)

Chapter 3: Featuring Configuration – Web UI
Featuring Configuration – Web UI
NGSME16T2H User Manual | 176
QoS / Ingress Port Policer Config
This page allows you to configure the Policer settings for all switch ports. The
settings relate to the currently selected stack unit, as reflected by the page header.
The displayed settings are:
Port
The port number for which the configuration below applies.
Enabled
Controls whether the policer is enabled on this switch port.
Rate
Controls the rate for the policer. The default value is 500. This value is restricted to
100-1000000 when the "Unit" is "kbps" or "fps", and it is restricted to 1-3300 when
the "Unit" is "Mbps" or "kfps".
Unit
Controls the unit of measure for the policer rate as kbps, Mbps, fps or kfps . The
default value is "kbps".
Buttons
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved
values.