Upnp configuration – Niveo Professional NGSME16T2H User Manual

Page 192

Advertising
background image

Chapter 3: Featuring Configuration

– Web UI

Featuring Configuration

– Web UI

NGSME16T2H User Manual | 192

UPnP Configuration

Configure UPnP on this page.

Mode

Indicates the UPnP operation mode. Possible modes are:

Enabled: Enable UPnP mode operation.

Disabled: Disable UPnP mode operation.

When the mode is enabled, two ACEs are added automatically to trap UPNP related

packets to CPU. The ACEs are automatically removed when the mode is disabled.

TTL

The TTL value is used by UPnP to send SSDP advertisement messages. Valid

values are in the range 1 to 255.

Advertising Duration

The duration, carried in SSDP packets, is used to inform a control point or control

points how often it or they should receive an SSDP advertisement message from

this switch. If a control point does not receive any message within the duration, it will

think that the switch no longer exists. Due to the unreliable nature of UDP, in the

standard it is recommended that such refreshing of advertisements to be done at

less than one-half of the advertising duration. In the implementation, the switch

sends SSDP messages periodically at the interval one-half of the advertising

duration minus 30 seconds. Valid values are in the range 100 to 86400.

Buttons

Save: Click to save changes.

Reset: Click to undo any changes made locally and revert to previously saved

values.

Advertising
This manual is related to the following products: