Niveo Professional NGSME16T2H - Manual (Page 358)

Chapter 5: Monitor, Diagnostic, Maintenance
Monitor, Diagnostic, Maintenance
NGSME16T2H User Manual | 358
Maintenance
The section allows user to maintain the switch, such as Reset Factory Default,
Firmware upgrading, Configuration Save/Restore and Restart the device.
Restart Device
You can restart the switch on this page. After restart, the switch will boot normally.
Yes: Click to restart device.
No: Click to return to the Port State page without restarting.
Factory Defaults
You can reset the configuration of the switch on this page. Only the IP configuration
is retained.
The new configuration is available immediately, which means that no restart is
necessary.
Yes: Click to reset the configuration to Factory Defaults.
No: Click to return to the Port State page without resetting the configuration.
Note: Restoring factory default can also be performed by making a physical
loopback between port 1 and port 2 within the first minute from switch reboot. In the
first minute after boot, 'loopback' packets will be transmitted at port 1. If a 'loopback'
packet is received at port 2 the switch will do a restore to default.