Niveo Professional NGSME16T2H - Manual (Page 242)

Chapter 4: Feature Configuration - CLI
Featuring Configuration
– CLI
NGSME16T2H User Manual | 242
LLDP Configuration
Feature Command Line
LLDP Parameters
LLDP Timers Syntax:
LLDP Interval [<interval>]
LLDP Hold [<hold>]
LLDP Delay [<delay>]
LLDP Reinit [<reinit>]
Example:
LLDP>interval 30
LLDP>hold 4
LLDP>delay 2
LLDP>reini 2
LLDP Mode Syntax:
LLDP Mode [<port_list>] [enable|disable|rx|tx]
(rx=RX Only, tx=TX Only)
Example: Enable LLDP on Ports
LLDP>mode 1-10 en (Port 1-10 are enabled)
LLDP>mode 1-26 en (Port 1-26 are enabled)
CDP aware Syntax:
LLDP cdp_aware [<port_list>] [enable|disable]
Example: Enable CDP on Port 1-5
LLDP>cdp_a 1-5 en (CDP on Port 1-5 are enabled)
LLDP Optional_TLV
Parameters
Syntax:
LLDP optional_TLV [<port_list>]
[port_descr|sys_name|sys_descr|sys_capa|mgmt_addr]
[enable|disable]
Example: